Quick Answer: How do you light an electric furnace?

On most electric ignition furnaces there is an ignition button, with a smaller red button right next to it. If you’re not able to locate this, check your owner’s manual for specific instructions. Press on this small button as you press the button for the electric ignition simultaneously.

Is there a pilot light on a electric furnace?

Although today’s standard electric furnace uses a hot surface ignition, older models often use an intermittent pilot to ignite heat. If you can’t get the pilot in your electric furnace to light, it’s usually a simple matter to turn it back on.

How do I light my electronic ignition furnace?

To light a gas furnace with electronic ignition, start by turning the furnace’s thermostat to its lowest setting. Cut off the power to the furnace next then turn the igniter off and wait for the gas to clear. After waiting, you can switch the igniter back on, bring the power back, and watch the pilot light come alive.

Can you manually light an electric furnace?

Never attempt to light a furnace by a flame manually, especially if the furnace has an electronic igniter. A furnace equipped with an electronic igniter cannot be lit manually. Call for the services of a professional heating and cooling technician when the igniter is not working properly.

NEED TO KNOW:  How is temperature controlled in a nuclear plant?

How do I turn on my electric pilot light?

Turn the valve to the “pilot” position. Press and hold the reset button. If the reset button fails, ignite the lighter. Hold down the reset button and bring a grill lighter or long match to the pilot light valve until the pilot ignites.

Why won’t my electric furnace turn on?

Make Sure the Breaker is On

If your heater won’t turn on, you should locate the fuse box in your home and then make sure that the breaker to your furnace is on. … Additionally, if you find that there is no power going to your electric furnace, it’s possible that you are experiencing a blown heating fuse.

How do I reset my electronic ignition furnace?

To reset the ignition control module on an electronic-ignition furnace, turn down the thermostat or turn off the power switch. Listen for the sound of the spark or watch for the hot surface ignitor to glow. Next, make sure the furnace’s flame sensor is clean.

What do I do if my pilot light won’t light?

How to Fix Your Pilot Light

  1. Find your gas valve. …
  2. You need to turn the valve to the off position for at least three minutes.
  3. Once you have had the valve at off for a few minutes, switch it over to pilot setting.
  4. You will need a match that is lit. …
  5. Set the pilot valve to the on position.

Can you light a furnace with a lighter?

Use a long lighter to light the furnace pilot light. … If it doesn’t light the first time, wait a few minutes and try again, this time holding the reset button down for 45 to 60 seconds. Your flame should be blue-green with a bit of yellow at the tip. This means it’s getting hot enough to heat the thermocouple properly.

NEED TO KNOW:  Does induction range use more electricity?

Is there a flame in an electric furnace?

Pros of an electric furnace

The most important one is that it takes very little time to heat up the house as opposed to gas and oil furnaces. The absence of combustion also makes them very safe and environment friendly. You won’t have to worry about your house catching fire or being stuffed with carbon monoxide.